NETWORK: SETTING UP STATIC IP ADDRESS EASY START GUIDE: Forces DVR/NVR to use the same IP address all the time, preventing your router from assigning a different address after a power cycle.  Required when port forwarding the DVR/NVR for remote access. Right click the main screen to bring up the option list and select “Menu” - you will be prompted to enter your password in order to advance.  Enter the default password  “admin12345” and then click the enter button, followed by clicking OK.  After clicking OK you will see the main system Menu.  Click the Configuration menu option. This will open the Configuration menu into the General settings tab.  Click the Network tab on the left side bar to enter the network settings. From here you can click on the IPv4 address to allow for manual entry.  First clear the existing IP address using the                        button.  Enter an IP address that matches your network’s subnet (usually 192.168.1.xxx or 192.168.0.xxx).  If you are not sure what subnet you are using, you may need to call for assistance. Next enter the subnet mask (255.255.255.0) and then the IPv4 Default Gateway.  The IPv4 Default Gateway is typically the IP address for your router, the most common addresses for this are 192.168.1.1 or 192.168.0.1 The last thing to configure is the Preferred and Alternate DNS servers which are typically provided by your ISP (internet service provider) but if you don’t know your DNS use 8.8.8.8 and 8.8.4.4 in these fields Click Apply to complete your changes and then click Liew View to exit the Menu.  
ARMIX CCTV® 2016 - All Rights Reserved
ARMIX CCTV® 2016 - All Rights Reserved  
NETWORK: SETTING UP STATIC IP ADDRESS EASY START GUIDE: Forces DVR/NVR to use the same IP address all the time, preventing your router from assigning a different address after a power cycle.  Required when port forwarding the DVR/NVR for remote access. Right click the main screen to bring up the option list and select “Menu” - you will be prompted to enter your password in order to advance.  Enter the default password  “admin12345” and then click the enter button, followed by clicking OK.  After clicking OK you will see the main system Menu.  Click the Configuration menu option. This will open the Configuration menu into the General settings tab.  Click the Network tab on the left side bar to enter the network settings. From here you can click on the IPv4 address to allow for manual entry.  First clear the existing IP address using the                        button.  Enter an IP address that matches your network’s subnet (usually 192.168.1.xxx or 192.168.0.xxx).  If you are not sure what subnet you are using, you may need to call for assistance. Next enter the subnet mask (255.255.255.0) and then the IPv4 Default Gateway.  The IPv4 Default Gateway is typically the IP address for your router, the most common addresses for this are 192.168.1.1 or 192.168.0.1 The last thing to configure is the Preferred and Alternate DNS servers which are typically provided by your ISP (internet service provider) but if you don’t know your DNS use 8.8.8.8 and 8.8.4.4 in these fields Click Apply to complete your changes and then click Liew View to exit the Menu.